There are also an array of sensors in the engine when faulty, will trigger the engine warning light. The RAM ProMaster check engine light can come on simply due to a loose gas cap or poor fuel quality. If the light continue to flash, seek immediate attention. If the engine light flashes, you should avoid heavy acceleration, deceleration and high engine speeds as this can result in catalytic converter damage. In most situations, if the engine light remains steady lit, it’s safe to continue driving, but it’s advised to have the fault rectified as soon as possible to avoid long-term damage. If the check engine light stays on, or comes on while driving the van, it means the Onboard Diagnostic System (OBD II) has detected a fault. The RAM ProMaster check engine warning light comes on when the ignition is set to on as part of a bulb check. It’s advised to drive with high caution and have the brake system serviced immediately. If the RAM ProMaster ABS light and brake warning light both illuminate, it means there’s a fault with the EBD system. EBD helps to distribute brake force to individual wheels, improving the van’s braking ability. Vans equipped with the Anti-Lock Brake System (ABS) are also equipped with Electronic Brake Force Distribution (EBD). A very common cause of the ABS light is due to a fault wheel speed sensor – there’s one located at each wheel. If the ABS light remains lit, it means the ABS has malfunctioned, however, normal brakes remain unaffected. The RAM ProMaster anti-lock braking system (ABS) warning light comes on with the ignition for around 4 seconds, then goes out as part of a bulb check. After it is armed, the warning light will flash slowly until the alarm system has been disarmed. The security warning light flashes quickly for around 15 seconds whilst the van’s security alarm system is arming itself. In this instance, have your brake system serviced immediately. If the parking brake is properly released and the brake fluid level is at an acceptable level, it may indicate a fault with the brake hydraulic system or that a problem with the brake booster has been detected by the Anti-Lock Brake System (ABS) / Electronic Stability Control (ESC) system. Check the brake master cylinder reservoir levels and top up if required. If the parking brake is fully released, yet the brake warning light remains lit, it may be an indication of low brake fluid. The red brake warning light illuminates when the parking brake is applied. Driving with low oil pressure will cause significant engine damage due to internal components not being properly lubricated. Low oil level can be the cause of the low oil pressure light coming on, but do not continue driving until you have located the cause. If this light comes on while driving, safely pull of the road, stop and switch off the engine immediately. The oil pressure warning light illuminates to warn of low engine oil pressure. Frequent topping up of coolant usually indicates a leak in the system. When the engine has sufficiently cooled, check coolant levels and add fluid if required. If the temperature does not return to normal, switch off the engine. Switch off the A/C system if it’s on and idle the engine for a period of time. IF the light comes on while driving, safely pull over and stop the van. The illumination of the engine temperature warning light means the RAM ProMaster coolant is too hot.
#Code alarm pro 3500 software
Some common transmission faults include the transmission Control Module, transmission fluid / filter (certain versions only) or a software update. As with many other warning lights, always have diagnostics in order to scan fault codes. It may come on along with a audible buzzer. The RAM ProMaster exclamation point inside a cog is the transmission fault warning light.
ETC light may illuminate along with the check engine warning light. Many more issues can trigger the ETC warning light and as a result, have a diagnostics scan for fault codes. If it continues to stay on or flash, the van may go into reduced performance mode, otherwise known as limp mode.Ĭommon RAM ETC problems can be related to throttle body, EGR valve, MAP sensor. Sometimes an engine restart will result in the ETC light going off. The RAM ProMaster Electronic Throttle Control (ETC) looks like a lightening bolt symbol and the warning light may illuminate or flash. If you’re driving the van when the battery light comes on, to help conserve battery charge and to remain mobile for as long as possible, immediately switch off any vehicle utilities that consume electric and that are not essential. Other wiring that connects components to the charging system.If the battery isn’t being charged, there’s a high possibility that the van may breakdown. If the RAM ProMaster battery warning light stays on, or intermittently comes on, it’s usually an indication that there’s a problem with the electrical charging system.
0 kommentar(er)
